Zero VOC Flat Paint
Safecoat Zero VOC Flat is a premium quality, fast curing paint designed for interior surfaces where a flat finish and superior film formation properties are needed. Safecoat products are uniquely formulated for optimal indoor air quality and minimal exposure to chemical toxicity. They are ideally suited for areas in which the health of occupants is a priority, including schools, hospitals, homes and offices. Safecoat paints contain no formaldehyde, ammonia, aromatic hydrocarbon compounds, exempt solvents or hazardous air pollutants.
Use Safecoat Zero VOC Flat paint on new or existing, properly primed interior walls and ceilings, properly cured and primed plaster, masonry, woodwork and primed metal.
SURFACE PREPARATION: Surfaces should be in good condition and free of dirt, dust, grease, oil, wax, mold and mildew. To achieve an even, consistent finish, the underlying surface must be evenly sealed. Before application, coat new wallboard or sheetrock with Safecoat New Wallboard Primecoat. Sand porous new wood and prime with Safecoat Transitional Primer. In all cases, the best finish will be achieved with a primer and two finish coats.
DRYING/CURING TIME: Under normal conditions, Safecoat Zero VOC Flat can be recoated after 4 hours, but for best results wait at least 8 hours before recoating. Drying and curing time can be accelerated by moving fresh air over the painted surface, but recoating sooner than noted above is not recommended.
COVERAGE: Up to 350 sq ft/ gallon in one coat, depending on surface porosity and method of application.
SIZES: Quarts, Gallons and 5-Gallons
LIMITATIONS: Unlike conventional paints, Safecoat is made without formaldehyde preservatives or toxic mildewcides or fungicides. Therefore, store Safecoat paints in airtight containers and do not contaminate.